HOME 900LC 700 YPXS 900F OPTIONS ABOUT US

Please note: There are some small differences in the various model years of the XSR700. However, the kit is

adaptable to fit all models with consideration for the following points:

The pre-2021 bikes are all okay to fit the kit directly.

All 2021 onwards bikes need either an aftermarket exhaust, or a pre-2021 standard exhaust in order to fit the belly pan.

All 2022 onwards bikes also need the pre-2022 steel headlight mounting sub-bracket to fit the VM headlight brackets.

Other than that, everything should work  fine.

You can order a new bike through Wigan Yamaha (speak to Rob Ocego) or alternatively there are plenty of low mileage used XSR700s at reasonable prices available second-hand, so your best bet is to source a standard bike from ebay or Autotrader and either we can supply you with a kit (painted or unpainted) to install yourself, or we can do a full ride-in-ride-out service by installing a kit to your existing bike.

To carry out the work on an existing bike is this:

Kit unpainted £1,450

Paintwork £1,570

Installation £650

Grab rail £120

With any of the above options you can also add any of these:

Akrapovic including carbon can £911

Yoshimura with black or silver can £875/£967

Lextek exhaust including carbon can £430

ECU re-flash with fuel map £329

K-Tech fork cartridge kit & rear shock (inc springs & install) £1650

Powder coated frame and swing arm (inc. strip & rebuild) £1,600

Cerakote axle blocks, footrest hangers & heel plates £45 (if done with frame etc)

Painted wheels £299 single colour, or £350 with silver rim

Quick action throttle & cables £99

Kit consists of:

nose cone with screen & screws, tail piece with grab rail rubbers & rear aperture rubber side panels with mounting bullets, belly pan with mounting brackets, rear mudguard (not the hugger) rear light lens, (with rubbers and spacers), rear light mounting bracket (with rubber seal). Stainless brackets include: grab rail bracket, front indicator mount, side panel brackets (with rubbers), headlight stay, lower nose cone bracket. Ally cnc machined headlight mounting brackets seat base (to extend original plastic base), seat foam (pillion section), seat cover (choice of stitching: red, blue, yellow, grey), seat release cable. And instructions along with all fasteners needed for the job.

If you wish to have it supplied already painted then an exchange service for your original petrol tank panels and

front mudguard is available provided you are in the UK. Once your paintwork is ready, you just send your original parts in for exchange, minimising the time your bike is off the road.

Please note*

*Kits are sold as complete units, and we do not sell parts individually unless you have already purchased a complete kit/bike from us, so there isn’t an option to buy just the side panels.

*Please also note, this kit only fits the XSR700, not the 900 or the MT-07